User guide

STEP 22 (8 Places)

With unit centered side to side, mark the holes in the Mounting

base (A). Move the unit out of the way enough to drill the 5/16"

ia. holes. Reposition unit and secure to the van roof with the

5/16-18 x 1-1/4" Fasteners.

CAUTION

To keep debris out of your

yes when drilling, always

wear protective eyewear.

NOTE: Seal the top of the bolts that go

through the roof with the sealant that is

supplied.

(A)

(8) 5/16

Rubber Washer

(8) 5/16"

Flat Washer

(8) Mounting

Pad-Rubber

(

8) 5/16-18 x 1-1/4"

Hex Hd. Bolt

(8) 5/16-18

Nylon Lock Nut

(8) 1-1/2" OD

Fender Washer

Roof Rib

STEP 23

Assemble Upper Handle Section to Lower Handle

Section, Snap into position at a convenient height.

Handle is removable and should not stay on rack

when vehicle is in motion.

Store Handle inside vehicle when transporting

Insert Handle Assembly into rack and

turn clockwise to lock into place. To

remove from rack, push up, turn coun-

terclockwise, and pull.

adjust to desired length

and snap into place.

1-1/2" OD