User guide

STEP 1

Slide a White Plastic Bushing (A)

nto the Pivot Arm (B) as shown.

(A)

(B)

STEP 2

Use the supplied lubricant and coat the pre-assembled

Black Plastic Bushing (A). Insert the Driveshaft/Handle

Assembly (B) into the larger Black Plastic Bushing (C)

in the Rear Cross-Member Assembly (D) and through the

White Plastic Bushing in the Pivot Arm (Step 1) so that the

black bushings are fully seated.

(B)

(C)

(D)

STEP 3

Align holes in the Pivot Arm, White Plastic Bushing, and

Rear Drive Tube. Install the 3/8-16 x 2-1/4" Fastener. Next

install the 5/16-18 x 1" Fastener as shown.

* 3/8-16 x 2-1/4"

Hex Hd. Bolt

(A)

5/16-18 x 1"

Hex Hd. Bolt

3/8-16 Nylon

Lock Nut

(2) 3/8"

Flat Washer

5/16-18 Nylon

Lock Nut

5/16" Flat

Washer

NOTE: Tighten all marked (*)

fasteners to 200 in. lbs.