Manual

1
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
This product is only intended and only safe for transporting ladders. It is the responsibility of the user to secure these materials to the rack before
transporting.
Ladders must be secured per ANSI standard A142.2-1990 paragraph 8.4.4. Ladder damage will occur from road shock and vehicle vibration if the
ladder is not properly secured to the ladder rack. Bouncing and side to side motion of an improperly secured ladder will cause wear and weaken the
ladder. Using a damaged ladder could lead to structural collapse resulting in serious injury or death. Place ladder in a raised position before transporting.
Driving with rack in lowered position may cause serious injury or damage to vehicle, ladder, rack or persons.
WARNING
WWW.WEATHERGUARD.COM
VAN STORAGE SOLUTIONS
INSTALLATION TIME
Approximate installation time: 20 minutes per unit depending van equipment installation experience.
– NOTICE –
Any modication or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries
to persons or property resulting from any modication to, or unintended use of this product.
CAUTION
Never load your rack to exceed the safe capacity of your vehicle. Heavy loads when carried high can dangerously alter the center of gravity.
Loads should be approximately centered front to rear. Failure to do this will cause damage to the vehicle roof. Long loads that extend out the rear
of the vehicle will prevent the rear hatch from fully opening and cause damage if attempted.
FOR THE WAY YOU WORK
Part No. 24-0100 REV. E ECN 5315 05/13
INSTALLATION MANUAL
261-3-01 Nissan NV Standard Roof Rack, 2507 Nissan NV Rail Mounting Kit,
262-3-01 Nissan NV High Roof Rack and 2506 Nissan NV Rail Mounting Kit
Model Qty Description
261-3-01 1 285-3-01 EZ-GLIDE
®
Ladder Rack
1 2507 Nissan NV Rail Mounting Kit
262-3-01 1 280-3-01 EZ-GLIDE
®
Drop Down Ladder Rack
1 2506 Nissan NV Rail Mounting Kit
PARTS LIST
TOOLS REQUIRED
• Open or Box End Wrench 9/16", 1/2" • Needle Nose Pliers
• 3/8" Drive Socket 9/16", 1/2" • 3/8" Drive Torque Wrench (in. lbs.)
• 3/8" Drive Ratchet • Tape Measure
• Phillips Screwdriver (Large) • Flat Screwdriver (Small)
• 5mm Hex Wrench
Front
Rear
END CAP
MOUNTING SCREW
RAIL CLAMP
MOUNTING NUT
16 x
MOUNTING RAIL
Front
Rear
END CAP
MOUNTING SCREW
RAIL CLAMP
MOUNTING NUT
20 x
MOUNTING RAILS
High RoofStandard Roof

Summary of content (9 pages)