User Manual

ManualsBrandsWEATHER GUARD ManualsAccessories for videoModel 8867-3-01 Work Top, Steel, 1-1/2 in x 42 in x 18 in

PAGE 1IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US TOLL-FREE AT 1.800.456.7865

PARTS

Item Qty. Description

Work Top

olt Kit #32-0101

INSTALLATION MANUAL

WORKTOP MODEL 8867

ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.

These instructions are to be followed using the parts and fasteners

supplied for proper installation. Any modiﬁcations or improper

installation of this product will create a hazardous condition that

can cause property damage, serious personal injury or death.

Any modiﬁcation or unintended use of this product shall immediately

void all manufacturers warranties. Manufacturer disclaims all liability

for injuries to persons or property resulting from any modiﬁcation

to, or unintended use of this product.

Approximate Assembly and Installation Time:

0 m

. (.3 hours) depending on van equipment

installation experience.

WARNING – NOTICE –

1 NOTE: The unit(s) this work top is to be

mounted on, must be the correct width or

properly spaced to accept the mounting

method.

Place the Work Top in position and mark the

center point of the bolt holes that will require

fastening.

NOTE: Mark

center of bolt hole carefully

since an off-center Blind Fastener makes

installation difﬁcult.

Remove work top and drill where marked

with 1/8" drill bit for pilot holes. Redrill

holes to enlarge them, using a 13/32"

drill bit. Install Blind Fasteners. (See

INSTALLATION INSTRUCTIONS

FOR

BLIND

FASTENERS on page 2).

Attach Work Top using four (4) 1/4-20 x 3/4"

Hex Head Bolts and 1/4" Lock Washers.

INSTALLATION IS NOW COMPLETE.

TOOLS REQUIRED

• Electric Drill

• Drill Bits: 13/32", 1/8"

• Open End Wrenches: 7/16", 9/16"

Part No. 24-0244 REV. B ECN 5305 04/13

Summary of content (2 pages)

PAGE 1
INSTALLATION MANUAL WORKTOP MODEL 8867 ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT. WARNING – NOTICE – These instructions are to be followed using the parts and fasteners supplied for proper installation. Any modifications or improper installation of this product will create a hazardous condition that can cause property damage, serious personal injury or death. Approximate Assembly and Installation Time: 20 min. (.
PAGE 2
BOLT KIT #32-0101 NOTE: Depending on your application you may end up with extra hardware after installation is complete. 4 1/4-20 Blind Fasteners 4 1/4" Lock Washers 4 1/4-20 x 3/4" Hex Head Bolts 1 Blind Fastener Installation Tool 1 1/4-20 x 2-1/4" Hex Head Black Bolt INSTALLATION INSTRUCTIONS FOR BLIND FASTENERS CAUTION 7/16” Wrench (Or 7/16” Socket) To keep debris out of your eyes when drilling, always wear protective eyewear.