Owner's manual

3
Place a drop of oil on the black oxide bolt before
assembling as shown on right. Place the Blind Fastener in the
hole and use a 7/16" wrench to tighten black hex bolt until the
Blind Fastener is fully seated. When setting black hex bolt, it will
start out hard. As the Blind Fastener “bulbs” out it will get easier,
until it bottoms out or sets. Make sure the Blind Fastener and
Installation Tool do not turn during installation.
INSTALLATION INSTRUCTIONS FOR BLIND FASTENERS
Flat Washer
9/16” Wrench
Installation Tool
Blind Fastener
Black Oxide Bolt
7/16” Wrench
(Or7/16”Socket)
STEP 3:Two(2)MountingStrapsand
Mounting Strap Angles are provided. The
Mounting Straps can be bent to any shape
and/or used with the Mounting Angles. The
Mounting Straps should be attached to the
upper portion of any product mounted on
top of this Cabinet in a manner that would
minimize movement of the unit both front to
rear and side to side. Attach the Mounting
Strapstotheunitthroughexistingholes(or
drillnewholesusinga5/16"drillbit)and
fasten with 1/4-20 x 5/8" Hex Head Bolts,
1/4" Flat Washers and 1/4-20 Nylon Lock
Nuts.
Fasten the other end of the Mounting Straps by
installingtwo(2)BlindFastenersinthewallorwall
ribs at the Mounting Strap locations by pre-drilling
1/8" holes and then re-drill the holes with a 13/32"
drill bit. Set the Blind Fasteners in the holes per
theINSTALLATIONINSTRUCTIONSFORBLIND
FASTENERSbelow.
RealigntheMountingStraps/MountingStrap
Angles on top of the Blind Fasteners and secure
themtothewallorwallribusingtwo(2)1/4-20x
3/4" Hex Head Bolts and 1/4" Lock Washers.
NOTE: If no product is mounted to the top of the
unit, the unit must be attached to the wall.
INSTALLATION IS NOW COMPLETE.