Installation Guide

1
WEATHERGUARD.COM
Installation via Hitch Harness
For Chevrolet, GMC or Ram Pickup Trucks
with the factory trailer towing package only
CONNECT NEW TRUCK BOX
HARNESS TO TRUCK
Locate the factory wiring hitch harness under or behind the
rear bumper of your truck. Disconnect the existing connec-
tors as shown below. Note that there is a locking tab that
needs to be depressed to disconnect the harnesses. Connect
your Weather Guard
®
Hitch Harness between the factory
connectors as shown below.
Tuck in and secure the Weather Guard
®
Hitch Harness to the
bumper, bed, or existing factory wiring harness using zip ties.
ROUTE HARNESS TO TRUCK BED
Route the new harness between the rear bumper and the
knock out hole in the bulkhead of the truck bed. It is usually
easiest to follow the path of an existing wiring harness along
the frame of the truck (recommend driver side). Secure the
new harness to the truck in a few locations using the zip ties
supplied.
ROUTE HARNESS INTO TRUCK BOX AND CONNECT
Remove the knock-out plug from the bulkhead of the truck bed, feed the harness end into the truck bed and then through the
grommet in the side of the truck box. Inside the truck box, connect the 2 pin connector to the light bar and tuck the excess wiring
inside the gas spring guard.
STEP 1
STEP 2
STEP 3
NO CUTTING OR DRILLING REQUIRED TO INSTALL. USE ZIP
TIES TO SECURE CABLE TO FACTORY FITTED PARTS.
New
Connector
SECURE WITH
ZIP TIE
Existing
Connector
Existing
Connector
2 pin
connector
plug
Bulkhead
knock-out plug
Truckbox
grommet
!
CHECK THE FUNCTIONALITY
With the lid open, LEDs should be lit. Close the lid approximately ¾ of the way and confirm LED lights turn off.