Instructions / Assembly

SECURE SCREEN (CONTINUED)

c. Drive sill screws

approximately 4” from

either end to anchor Sill

Plate & Extenders in-place,

and 4” to the left and

right of center to further

anchor the Sill Plate. Do

not over tighten.

#6 x 3/4”

Sill Screws

Qty: 4

Unpainted

VERIFY LATCH ALIGNMENT

a. Deploy Slider Bar with Latch Hook until it reaches the middle of the Track. Mark the

position of the Slide Bolts on the Sill Plate and top molding.

If needed, adjust Slide Bolt positions using screw shown in Step 1d.

b. Release the Slider Bar and

drill 1/4” holes in the Sill Plate

and the top molding. Remove

any burrs or sharp edges.

Deploy the Slider Bar with Latch

Hook to the middle of the track.

Drop Slide Bolts into these top

and bottom holes.

Note: Drill only deep enough for

the Slide Bolt to fully engage.