Installation Guide
Top and
bottom
2-piece
drop-in
brackets
# 14 Type F
self-threading
screws
Straight Aluminum Railing Kit Instructions
• Consult your local building code official and check all Code Requirements
• Read all instructions thoroughly prior to assembly to assure correct installation. THE
MANUFACTURER WILL NOT BE HELD RESPONSIBLE FOR UNSAFE OR INCORRECT
INSTALLATION.
• These instructions are guidelines and do not cover every installation scenario
• Always use the fasteners provided in the railing kit. DO NOT swap any hardware.
• This railing kit has been tested by ATI and meets the IRC and IBC construction code standards
• Always follow all safety regulations when installing the railing section and always wear safety
glasses
• Purchaser has the sole responsibility to determine whether the aluminum railing and aluminum
post products comply with the applicable codes and are appropriate for the intended use. The
purchaser and installer should review the intended use of the products with a licensed
professional engineer to determine code compliance. Aluminum railing products are tested to meet
IRC and IBC Codes; additional testing information is available upon request.
• Cordless Drill/Impact Driver
• 13/64” Drill Bit
• #3 Phillips Screwdriver Bit
• Speed Square
• 2’ Level
• Post level (optional)
• Tape Measure
• Clamps (x2)
• Miter saw or portable band saw
• Rubber Mallet
TOOLS
HARDWARE & PROFILES
BEFORE YOU BEGIN INSTALLATION:
¾” Square
Balusters
Foot
block kit