Installation Guide

A
A - 3/4"
1
3
RESTING FLANGE
2
4
1 -CUT THE BOTTOM RAIL TO THE DESIRED LENGTH AND ANGLE TO MATCH THE STAIR ANGLE AND THE DISTANCE BETWEEN THE STAIR POSTS MINUS 3/4". PLACE A MOUNTING
PLATE ON EACH END OF THE RAIL, MAKING SURE THE BOTTOM OF THE RAIL SITS ON THE RESTING FLANGES. TEMPORARILY PLACE INTO POSITION AT THE DESIRED DISTANCE
ABOVE THE TREAD RISERS. MARK THE LOCATIONS OF THE BOTTOM OF EACH MOUNTING BRACKET, THEN REMOVE THE RAIL.
2 - USING FOUR OF THE SUPPLIED SCREWS, INSTALL THE LOWER MOUNTING PLATES BY CENTERING THEM ON THE POSTS WHILE ALIGNING THEM WITH
THE LOCATION MARKS CREATED IN STEP ONE.
3 - REPEAT STERP 1 AND 2 ON THE UPPER RAIL. THE DISTANCE THE TOP MOUNTING PLATES WILL BE ABOVE THE BOTTOM MOUNTING PLATES WILL BE THE SAME DISTANCE
THAT THE BOTTOM OF THE BOTTOM RAIL IS TO THE BOTTOM OF THE TOP RAIL ON THE RAILING SECTION TO BE INSTALLED.
4 - SLIDE THE BRACKET COVERS ONTO THE RAILING SECTION AS FAR BACK AS POSSIBLE. INSTALL THE ENTIRE RAILING SECTION INTO THE MOUNTING PLATES, MAKING SURE
THE RAILS SIT ON THE RESTING FLANGES.
5- INSTALL TWO OF THE SUPPLIED SIDE SCREWS INTO EACH MOUNTING PLATE (ONE ON EACH SIDE) CHOOSING THE BEST SLOT LOCATION TO MAKE SURE THE SCREWS
ENGAGE INTO THE STIFFENERIN THE RAIL. THE MOUNTING PLATES ARE SLOTTED TO ALLOW FOR THERMAL EXPANSION AND CONTRACTION.
6 - SLIDE THE COVERS TOWARDS THE POST UNTIL THEY SNAP ONTO THE MOUNTING PLATES. YOU WILL HEAR AN AUDIBLE "CLICK".
NOTE: WHEN BEING INSTALLED WITH A BLUMOUNT POST MOUNT SYSTEM, USE THE 1" LONG SCREWS PROVIDED WITH THE
HARDWARE KITS PART NUMBERS 1368 AND 1369 IN PLACE OF THE 1-1/2" LONG SCREWS PROVIDED
5
6
STAIR BRACKET INSTALLATION INSTRUCTIONS