Instructions / Assembly

MEASURES FROM THE DECK
THE BOTTOM EDGE OF THE RAIL WILL
REST ON THIS FLANGE.THIS WILL BE
THE DISTANCE THE BOTTOM RAIL
OF THE RAILING SECTION
THIS DISTANCE IS THE
MEASUREMENT FROM THE BOTTOM
EDGE OF THE LOWER RAIL TO THE
BOTTOM EDGE OF THE TOP RAIL
ON THE POST
CENTER THE BRACKETS
1
2
RESTING FLANGE
3
5
1 - USING FOUR OF THE SUPPLIED SCREWS, INSTALL THE LOWER MOUNTING PLATE ON TO THE POST. THE MOUNTING PLATES
SHOULD BE CENTERED ON THE POST WITH THE RESTING FLANGE AT THE REQUIRED DISTANCE FROM THE DECK.
2 - REPEAT THIS PROCEDURE ON THE UPPER MOUNTING PLATE. KEEP THE DISTANCE BETWEEN THE LOWER RESTING FLANGE TO
THE UPPER RESTING FLANGE THE SAME AS THE DISTANCE BETWEEN THE BOTTOM RAIL LOWER EDGE TO THE TOP RAIL
LOWER EDGE. REPEAT STEPS 1 AND 2 ON THE OPPOSING POST.
3 - SLIDE THE BRACKET COVERS ONTO THE RAILING SECTION. INSTALL THE ENTIRE RAILING
SECTION INTO THE MOUNTING PLATES, MAKING SURE THE RAILS SIT ON THE RESTING FLANGES.
NOTE: THE RAILING SECTION SHOULD BE CUT 3/4" SMALLER THAN THE DISTANCE BETWEEN THE POSTS.
4 - INSTALL TWO OF THE THE SUPPLIED SIDE SCREWS INTO EACH MOUNTING PLATE (ONE ON EACH SIDE) CHOOSING THE BEST
SLOT LOCATION TO MAKE SURE THE SCREWS ENGAGE INTO THE STIFFENER IN THE RAIL. THE MOUNTING PLATES ARE SLOTTED
TO ALLOW FOR THERMAL EXPANSION AND CONTRACTION.
5 - SLIDE THE COVERS TOWARDS THE POST UNTIL THEY SNAP ONTO THE MOUNTING PLATES.
YOU WILL HEAR AN AUDIBLE "CLICK".
NOTE: WHEN BEING INSTALLED WITH AN LMT BLUEMOUNT POST MOUNT SYSTEM, USE THE 1" LONG SCREWS PROVIDED WITH THE
HARDWARE KITS PART NUMBERS 1368 AND 1369 IN PLACE OF THE 1-1/2" LONG SCREWS PROVIDED
RESTING FLANGE
STRAIGHT BRACKET INSTALLATION INSTRUCTIONS
INSTALL SCREWS IN THE
APPROPRIATE SLOTS
4