Installation Guide

We’re happy to help. Call 1-855-224-9761.
7
Panel Installation
Solid Privacy
Solid Privacy with Lattice
1. Follow the layout and post installation
instructions on page 3
.
10. Pour concrete around post B to about 3 inches below ground level and level and plumb.
11. If there is a small gap at each end, position the u-channels to cover any gaps.
Post A
Post A
Aluminum
Aluminum
Post A
Post A
Aluminum
Aluminum
1.75" x 3.5" Hole
for rail in the post
7/8" x 1.5" lattice end
caps for each end of
the lattice strip
1.5" U-Channel slides
on the T&G picket
1.5" x 5.5" Hole
for rail in the post
1.5" x 5.5" Slotted rail
7/8" x 6" T&G pickets
slide into slotted rails
1.5" x 5.5" Rail with 1/4" rip
in the top to accept lattice
strip and 7/8" slot in the
bottom to accept the T&G
1.75" x 3.5" Rail with 1/4"
rip to accept lattice strip
Cap
1. Follow the layout and post installation
instructions on page 3.
2. Install the 1st post (post A) with concrete
around the post. Be sure to level and plumb.
3. Have another post (post B) sitting in the
adjacent hole.
4. Slide the bottom rail (with the aluminum
insert) and top rail into post A.
5. Slide the T&G pickets between the bottom
and top rails until the panel is complete. Be
sure to slide a u-channel on the first and last
picket.
6. Slide the bottom rail and then the top rail into
the second post (post B).
7. Pour concrete around post B to about 3
inches below ground level and level and
plumb.
8. If there is a small gap at each end, position
the u-channels to cover any gaps.
2. Install the 1st post (post A) with concrete
around the post. Be sure to level and plumb.
3. Have another post (post B) sitting in the
adjacent hole.
4. Slide the bottom rail (with the aluminum
insert) and the mid-rail into post A.
5. Slide the T&G pickets between the bottom
and mid-rails until this portion of the panel is
complete. Be sure to slide a u-channel on the
first and last picket.
6. Slide the bottom rail into post B.
7. Slide the top rail into post A.
8. Slide the lattice strip between the mid-rail
and the top rail. Add the lattice end caps on
each end of the lattice.
9. Slide the mid-rail and top rail into the second
post (post B).
Cap
1.5
" x 5.5" Slotted rail
7/8" x 6" T&G pickets
slide into slotted rails
1.5" x 5.5" Slotted rail
1.5
" U-channel slides
on the T&G picket
1.5" x 5.5" Hole
for rail in the post