Privacy Fence Gate Installation Guide
GATE ASSEMBLY INSTRUCTIONS ASSEMBLY OF PRIVACY GATE 1 Always start by doing a "Dry Fit" test without gluing. This allows you to make any necessary adjustments. Start the assembly by inserting the rails into the first gate socket post as shown. Install a u-channel on the first picket Feed the pickets into the slots of the rails. Continue installing the additional pickets. 2 Once you have finished installing the pickets, install the remaining Uchannel in the same manner as the first.
GATE INSTALLATION INSTRUCTIONS 1.5" xU-Channel 5.5" Hole rail in 1.25" slides onthe the T&G picket. Thefor following is post. based on an assembled gate that is properly sized for opening. Al Al SINGLE GATE INSTRUCTIONS A. B. C. Determine the direction the gate is to swing, usually swings into yard. Be sure to check your local codes! If you have aluminum post inserts, install prior to the installation of the gate.
SELECT YOUR PANEL STYLE FROM THE FOLLOWING DRAWINGS FOR AN ILLUSTRATION OF THE SCREW PLACEMENT FOR THE HIGH WIND INSTALLATION.
* Purchaser has the sole responsibility to determine whether these products comply with applicable codes and is appropriate for the intended use. The purchaser and installer should review the intended use of the products with a licensed professional engineer to determine code compliance and intended use.