Installation Guide
We’re happy to help. Call 1-888-743-3673.
Gate Assembly
2
1
1. Locate, lay out and dry-assemble all gate parts including gate socket posts, rails and pickets. Do not
use glue.
2. Insert the pickets to the bottom rail and through the top rail. Insert (and glue) picket caps into pickets
by putting a small strip of glue inside the picket, NOT on picket cap.
3. Measure the width at the top and bottom of gate to ensure your gate is a square. Measure diagonally
from the left and right to ensure both lengths are the same or within 1/8” of a difference.
4. Adjust as necessary.
1. Remove the rst gate post to ip it and insert a 1/8” bead of glue around the inside of the two pockets
down about 1/4” from the top of each pocket. Do next step quickly!
2. After glue is in the pockets of the rst post, ip posts to quickly insert the rails into the pockets.
3. Be sure to rmly insert the rails. The adhesive will set in 45 seconds.
2
Measuring Tape