Installation Guide

We’re happy to help. Call 1-888-743-3673.

Gate Assembly

1. Lay the cross-brace on the gate and mark the length to cut.

2. Pre-drill 2 holes into the cross-brace only. DO NOT pre-drill into the gate.

Tip : The cross-brace mounts to the rails only. It should run diagonally starting at the bottom of

the bottom rail, running diagonally to the top rail of the latch post.

Tip : The hinge side of gate is where cross-brace is at bottom. The latch side of gate is where

cross-brace is at top. Mark either side with tape to ensure cross-brace is installed correctly.

3. Attach the brace using 2 self-taping screws at each end of the gate.

1. Repeat the previous steps for the other post. This may take some assistance to do before the

adhesive sets.

2. Measure the top and bottom of gate to ensure both lengths are the same.

Measuring Tape