Fence Post Installation Guide
IMPORTANT GENERAL POST INSTALLATION When installing your fence or gate, we recommend a minimum of 2" clearance between the bottom of the panel and the ground. This will allow enough clearance for the gate to swing freely. Measure, assemble and install your gates first (even pre-cut gate kits). The installed gate will set the height of the fence being installed. Failure to do so may result in a poor installation. Dry fit the cut rails into gate socket posts.
HELPFUL HINTS: • • • • • If post does not already have a concrete hole from the factory, drill a hole at least 3/4" dia. 12" up from bottom of post. This will help concrete get into post. When gluing picket caps, place a thin bead of glue inside the picket and press picket cap into place. Post caps should not be glued in the event you want to upgrade to a different style. A small amount of clear silicone on the inside corner of post cap will secure cap to post.