Instructions / Assembly

We’re happy to help. Call 1-855-243-9761.
15
High Wind Installation
T&G Privacy - 110 MPH sustained winds with gusts up to 130 MPH
Step 1
Reinforce each post to at least
22" above ground with either
an aluminum insert (prior to
installing the fence) OR fill
each post with concrete (after
installing the fence) as shown
in figure 1. If using concrete,
be sure to tape off the rails to
prevent it from flowing into
the rails.
Step 2
Install one #10 x 1" self-tapping
stainless steel screw into the
top and bottom of each 6" wide
picket to secure the picket to
the top and the bottom rails.
Screws should be placed no
more than 1" from the top or
bottom of the rail. Be careful
not to over tighten the screws.
Step 3
Install a screw inside the post
on each side of the top rail as
seen in figure 2.
32" min.
22" min.
Ground level
Top view of rail in posts
Place screw here
Place screw here
Place screws no more
than 1" from the edge of
the rail
Concrete or aluminum insert
(at least 54" tall)
12" X 36" post hole filled with
concrete
T&G Privacy with Lattice Accent - 110 MPH sustained winds
with gusts up to 130 MPH
Step 1
Reinforce each post to at least
22" above ground with either
an aluminum insert (prior to
installing the fence) OR fill each
post with concrete (after installing
the fence) as shown in figure 1. If
using concrete, be sure to tape off
the rails to prevent it from flowing
into the rails.
Step 2
Install one #10 x 1" self-tapping
stainless steel screw into the top
and bottom of each 6" wide picket
to secure the picket to the bottom
and mid-rails. Screws should
be placed no more than 1" from
the top or bottom of the rail. Be
careful not to over tighten the
screws.
Step 3
To secure the lattice accent, install
additional screws approximately
10" apart into the top rail and the
mid-rail, being sure the screw goes through the rail into the lattice.
Step 4
Install a screw inside the post on each side of the top rail as see
n in figure 2.
Place screws no more
than 1" from the edge of
the rail
Concrete or aluminum
insert (at least 54" tall)
12" X 36" post hole filled with concrete
Figure 1
Figure 2
Figure 1
Place screw here
Place screw here
Top view of rail in posts
Figure 2