Installation Guide

We’re happy to help. Call 1-855-224-9761
.
5
Gate Assembly
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Step 2
Once assembly is complete,
measure to confirm the gate is
the same width on the top and
bottom.
Step 4
Leaving the panel assembled,
carefully remove the rails from
the socket posts. Turn the first
socket post up and run a 1/8"
bead of vinyl glue (included)
around the inner rim of the
sockets approximately 1/4"
down.
Step 6
Quickly repeat steps 4 & 5
for the other socket post.
This may take some
assistance to do before the
adhesive begins to set.
C
Cut and install the cross brace.
The brace should run at an
angle starting at the lower
corner of the gate on the hinge
side and run at an upward
angle towards the top. Be sure
to secure the cross brace to
the rails (not the posts).
Step 10
Install post caps on the tops
of the gate socket posts, using
a small amount of glue on the
inside corner of the post cap to
hold it in place.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Step 1
Always start by doing a "Dry
Fit" test. Do not use glue for
the initial "Dry Fit" assembly.
This allows for any necessary
adjustments. (Hint: If you
have a privacy fence be sure
to remember to install the
u-channels)
Step 3
Cross measure the gate
diagonally both ways to make
sure the measurements are
the same or within an 1/8"
difference. Be sure to read the
same side of the tape measure.
Failure to do so will result in the
wrong measurement. Make any
adjustments necessary before
moving to next step.
Step 5
After placing the glue in the
sockets of the first socket post,
flip it down and quickly and
firmly insert the rails into the
sockets. The adhesive will set
in about 45-60 seconds.
Step 7
Quickly repeat steps 2 & 3 to
confirm the measurements are
accurate. Allow the glue to dry
for one hour.
Step 9
Pre-drill three holes into the top
and bottom of the cross brace
only. DO NOT pre-drill into the
gate. Attach the cross brace
using two of the provided self-
tapping screws at each end of
the gate. Please note, 8 ft. high
panels require 2 cross braces.
See CAD for placement.
Step 8