Installation Guide

We’re happy to help. Call 1-855-224-9761.
10
Panel Installation
Solid Privacy with an Open Picket Top
8. Pour concrete around post B to about 3 inches below ground level and level and plumb.
9. If there is a small gap between the pickets and the post at each end, position the u-channels to cover any
gaps.
10. Lay the spindles out on the ground to create the desired look. Be sure to refer to the CAD diagram for
proper placement.
11. Insert the spindles with the notched side down through the routed holes in the top rail and into the mid-
rail.
12. Place a small drop of glue on the inside of each spindle and set the picket cap in place.
Solid Privacy with 3D Square Lattice
8. Slide the top rail into post A with the opposite end (at post B) angled upward towards the sky. Holding the
top rail at an upward angle, slowly line the spindles up with the routed holes in the top rail while lowering
the rail into place.
9. Once the panel is fully assembled, slide the bottom rail and then the mid and top rail into the second post
(post B).
10. Pour concrete around post B to about 3 inches below ground level and level and plumb.
Post A
Post A
7/8" x 1.5" Pickets
slide into routed holes
of the top end
1. Follow the layout and post installation instructions on
page 3.
2. Install the 1st post (post A) with concrete around the post.
Be sure to level and plumb.
3. Have another post (post B) sitting in the adjacent hole.
4. Slide the bottom rail (with the aluminum insert) and the
mid-rail into post A.
5. Slide the T&G pickets between the bottom and mid-rails
until this portion of the panel is complete. Be sure to slideuntil this portion of the panel is complete. Be sure to slide
a U-channel on the first and last picket.
6. Layout and assemble the lattice topper on the ground by
sliding the long horizontal picket through the routed
vertical spindles. Note, the two spindles on the outer
edges are only routed on one side.
7. Insert the spindles in the lattice topper into the routed
holes in the mid-rail.
1. Follow the layout and post installation instructions on
page 3.
2. Install the 1st post (post A) with concrete around the post.
Be sure to level and plumb.
3. Have another post (post B) sitting in the adjacent hole.
4. Slide the bottom rail (with the aluminum insert) and the
mid-rail into post A.
5. Slide the T&G pickets between the bottom and mid-rails
until this portion of the panel is complete. Be sure to slide
a U-channel onto the first and last picket.
6. Slide the top rail into post A. The larger routed holes in
the top-rail should face the ground.
7. Once this portion of the panel is complete, insert the
bottom rail and then the mid and top rails into the second
post (post B).
7/8" x 6" T&G
pickets slide
into slotted rails
1.5" x 5.5" Hole
for rail in the post
1.5" U-Channel slides
on the T&G picket
Aluminum
1.5" x 5.5"
Slotted rail
1.75" x 3.5" Top rail with
the underside routed to
accept 7/8" x 1.5" pickets
7/8" x 6" T&G pickets
slide into slotted rails
1.5" x 5.5"
Slotted rail
1.5" x 5.5" Hole
for rail in the post
1.5" U-Channel slides
on the T&G picket
1.75" x 3.5" Hole
for rail in the post
Aluminum
Cap