Installation Guide

We’re happy to help. Call 1-855-224-9761
.
14
Panel Privacy - 120 MPH sustained winds with gusts up to 137 MPH
Step 1
Reinforce each post to at least 22" above
ground with either an aluminum insert
(prior to installing the fence) OR fill each
post with concrete (after installing the
fence) as shown in figure 1. If using
concrete, be sure to tape off the rails to
prevent it from flowing into the rails.
Step 2
Install four #10 x 1" self-tapping stainless
steel screw into each 13.875" wide picket,
using 2 screws to secure the picket to the
top rail and 2 screws to secure the picket
to the mid-rail. Screws should be placed
no more than 1" from the top or bottom of
the rail. Be careful not to over tighten the
screws.
Step 3
Repeat step 2 to secure the pickets
between the mid-rail and the bottom rail.
Step 4
Next, install a screw inside the post on each
side of the top rail as seen in figure 2.
High Wind Installation
Panel Privacy with Lattice - 115 MPH sustained winds with gusts up to 130 MPH
Step 1
Reinforce each post to at least 22" above
ground with either an aluminum insert
(prior to installing the fence) OR fill each
post with concrete (after installing the
fence) as shown in figure 1. If using
concrete, be sure to tape off the rails to
prevent it from flowing into the rails.
Step 2
Install four #10 x 1" self-tapping stainless
steel screw into each 13.875" wide picket,
using 2 screws to secure the picket to
the mid-rail and 2 screws to secure the
picket to the bottom rail. Screws should
be placed no more than 1" from the top or
bottom of the rail. Be careful not to over
tighten the screws.
Step 3
To secure the lattice accent, install
additional screws approximately 10" apart
in the top rail and the mid-rail, being sure
the screws goes through the rail and into
the lattice.
Step 4
Next, install a screw inside the post on each side of the top rail as seen in figure 2.
Concrete or aluminum insert
(at least 54" tall)
12" X 36" post hole filled
with concrete
Place screws no more
than 1" from the edge of
the rail
Concrete or aluminum insert
(at least 54" tall)
12" X 36" post hole filled with
concrete
22” Min.
32” Min.
High Wind Installation WITH Fasteners:
If higher wind load capacity is required, follow the installation instructions found below. It is only necessary to
install fasteners on one side of the fence panel. Screws may be purchased from us or a local hardware store. Since
these screws are visible on the exterior of the fence panel, we recommend installing screw cap covers.
Ground level
Figure 1
Figure 1
Place screw here
Place screw here
Top of rail in posts
Figure 2
Place screws no
more than 1" from
the edge of the rail
Ground level
Place screw here
Place screw here
Top of rail in posts
Figure 2