Instructions / Assembly

CH350F SELF-CLOSING MULTI-ADJUSTABLE HINGE

INSTALLATION INSTRUCTIONS

PLEASE CAREFULLY READ ALL INSTRUCTIONS PRIOR TO INSTALLATION.

MAX GATE WEIGHT: 150 LBS.

Gate gap must be between 3/8” up to 1-5/8”

Tools Needed:

 Tape Measure & Pencil

 Drill with #3 Phillips bit

 11mm Wrench

 Level

1. Measure and place the mounting brackets on the gate and

fence post.

 The wide bracket is for vertical adjustment and should be

mounted on the fence post.

 The narrow bracket if for horizontal adjustment and

should be mounted on the gate.

 The brackets should be positioned on the outside

surfaces of the posts with the gate in the closed position.

2. Secure the mounting brackets with the 1-¼” flat

head screws.

 The top edge of the upper hinge should be

mounted within 6” of the top of the gate.

 The bottom edge of the lower hinge should be

within 6” of the bottom of the gate.

 The gate and post brackets should be centered

to one another as closely as possible.

PAGE 1
CH350F SELF-CLOSING MULTI-ADJUSTABLE HINGE INSTALLATION INSTRUCTIONS PLEASE CAREFULLY READ ALL INSTRUCTIONS PRIOR TO INSTALLATION. MAX GATE WEIGHT: 150 LBS. Gate gap must be between 3/8” up to 1-5/8” Tools Needed:     Tape Measure & Pencil Drill with #3 Phillips bit 11mm Wrench Level 1. Measure and place the mounting brackets on the gate and 2. Secure the mounting brackets with the 1-¼” flat fence post. head screws.
PAGE 2
3. Install SELF-CLOSING HINGE ASSEMBLY to the MOUNTING BRACKETS and lightly hand-tighten the acorn nuts and washers. 4. Using a level, adjust the gate until it sits straight and level inside the gate opening. Once the gate is level, tighten all of the acorn nuts with an 11mm wrench. Do not overtighten to avoid stripping the bolts. SPRING TENSION ADJUSTMENT AND MAINTENANCE IMPORTANT: Spring tension should never be increased more than 2 full turns (8 quarter turns) from the neutral position. 1.