Instructions / Assembly

3. Use the chart above and the size of your fence
post to determine the length of the lock spindle
and spindle housing (step 4). Use 2 pliers to
break the spindles at the designated mark. DO
NOT BEND THE SPINDLE WHEN BREAKING IT
OFF.
* Spindle housing of this size is included
4. If the spindle housings included are not the
proper length, cut the housing according to the
above chart.
 Assure the cut is straight and square.
Eliminate any burrs that result from cutting.
 Insert the spindle housing into the back
handle assembly completely, approximately
½”.
5. From the back side of the gate, slide the
back handle assembly through the 3/4" hole in
the gate. The assembly must sit flush to the
face and side of the gate. Center the assembly
with line drawn on the side of the gate and
attach the back housing using two 1-¼” screws
and one ¾” screw.
6. Install the front handle assembly.
 Rotate the lock spindle on the back handle assembly
counterclockwise until it stops.
 Assure the front handle assembly is in the unlocked position.
 Align the lock spindle and spindle housing with the front handle
assembly and slide the front handle assembly up against the
gate post.
 The front handle assembly must be flush with the gate. If it is
not, the spindle housing may need to be trimmed.
 Once the front handle assembly is in place, secure it with two 1-
¾”screws into the face of the assembly and two ¾” screws into
the side.
POST SIZE