Instructions / Assembly

7. Configure the front handle assembly and

the keeper assembly for left-handed or right-

handed operation as per your install.

 The keeper assembly can be slid out of the

mounting plate so that the mounting plate

can be rotated.

 The front handle assembly has a lower

cover that may need to be moved to the

bottom of the front handle assembly.

8. Install the keeper assembly:

 With the gate closed, draw a line on the fence post under the

front handle assembly.

 Position the keeper assembly on fence post so the bottom edge

is 1/8” above the scribe line and install using four ¾” screws.

 Adjust the keeper so that it is centered in the opening of the

front handle assembly. Slide the keeper up to uncover the

horizontal adjustment plate and secure with two of the small

adjustment locking screws.

 Slide the keeper back down and align the center hole on the

keeper with the fourth hole from the bottom of the mounting

plate. Secure with one adjustment locking screw.

9. Close the gate to ensure the latch is operating as intended. Once closed, the

latch should engage. Actuating the handle should dis-engage the latch. If the latch

does not engage, the keeper should be adjusted accordingly.

ADJUSTMENT:

To adjust the keeper assembly vertically or horizontally, remove the associated locking screw(s), slide to the required

position and reinstall the locking screw(s).

TROUBLESHOOTING:

If the lock does not lock properly, you may need to remove the front handle assembly and make sure the lock spindle

is turned counterclockwise all the way and the front handle assembly is in the unlocked position.

LOWER COVER

KEEPER

MOUNTING SCREW

VERTICAL ADJUSTMENT

LOCKING SCREW

HORIZONTAL ADJUSTMENT

LOCKING SCREW

MOUNTING SCREW

SCRIBE LINE