Installation Guide

We’re happy to help. Call 1-855-224-9761.
Gate Assembly
2
Step 1
1. Locate, lay out and dry-assemble all parts of the gate including posts, rails and pickets. Do not use
glue.
2. Insert the pickets into the top and bottom rails as needed.
3. Measure the width at the top and bottom of gate to ensure your gate is a square. Measure diagonally
from the left and right to ensure both lengths are the same or within 1/8” of a difference.
4. Adjust as necessary.
1. Remove the first gate post to flip it and place a 1/8” bead of glue around the inside of the two pockets down
about 1/4” from the top of each pocket. It is important to do next step quickly because the glue dries quickly!
2. After glue is placed in the pockets of the first post, flip the post and quickly insert the rails into the pockets.
3. Be sure to firmly insert the rails. The glue will set in about 45 seconds.
Step 2
Measuring Tape