Installation Guide

We’re happy to help. Call 1-855-224-9761.

Gate Assembly

1. Lay the cross-brace on the gate and mark the length to cut.

2. Pre-drill 2 holes into the cross-brace only. DO NOT pre-drill into the gate.

Step 4

Tip : The cross-brace mounts to the rails only. It should run diagonally starting at the bottom

of the bottom rail (near the hinge post) to the top rail (near the latch post).

Tip : The cross brace rests at the bottom on the hinge side of the gate. The latch side of gate is the

side where cross-brace is at the top. We

recommend marking the hinge side with a piece of tape

so you can easily differentiate the hinge side from the latch side. This will help ensure cross-

brace is installed correctly.

3. Attach the brace using 2 self-tapping screws at each end of the gate.

1. Repeat the previous steps for the other post. This may take some assistance to do before the glue sets.

2. Next, measure the top and bottom of gate to ensure both lengths are the same.

Step 3

Measuring Tape