Use and Care Manual

ManualsBrandsWeatherguard ManualsOutdoors8 ft. x 12 ft. x 20 ft. Round Top Commercial Greenhouse

COMMERCIAL GREENHOUSE

ITEM# IS 63100 12’ wide x 8’6” high x 20’ long

MATERIALS DESCRIPTON QUANITY

INCLUDED

A Curved Pipe Male/Female 18

B Curved Pipe Male/Male 6

C Long Connector Bolts/Nuts 30

D Horizontal Straight Purlins 25

E Left Hand Corner Base 2

F Right Hand Corner Base 2

G Line/Wall Base 8

H Short Connector Bolts/Nuts 12

I Yellow Safety Connector Caps 42

J Corner Base Ratchets 4

K Front Door Zipper Panel 1

L Black Bungie Balls 62

M Back Solid Panel 1

N Top Cover 1

O Top Cover Lasing Ropes 2

P Diagonal Corner Brace Rods 4

ADDITIONAL MATERIALS (NOT SUPPLIED)

·Foundation Options:

Ground Direct, Pressure-Treated Lumber

or Railroad Ties or Concrete Slab.

Note: Read Steps #1 and #2

to determine your specific needs.

IS 63100 manual

from year 2008

Summary of content (6 pages)

PAGE 1
IS 63100 manual from year 2008 COMMERCIAL GREENHOUSE ITEM# IS 63100 12’ wide x 8’6” high x 20’ long MATERIALS INCLUDED A B C D E F G H I J K L M N O P DESCRIPTON Curved Pipe Male/Female Curved Pipe Male/Male Long Connector Bolts/Nuts Horizontal Straight Purlins Left Hand Corner Base Right Hand Corner Base Line/Wall Base Short Connector Bolts/Nuts Yellow Safety Connector Caps Corner Base Ratchets Front Door Zipper Panel Black Bungie Balls Back Solid Panel Top Cover Top Cover Lasing Ropes Diagonal Corner Br
PAGE 2
IMPORTANT NOTICE! PLEASE READ THESE INSTRUCTIONS COMPLETETLY PRIOR TO ASSEMBLING YOUR STORAGE SOULUTIONS™ SHELTER! ·This high-quality Storage Solutions™ Round Top Shelter requires tie downs to serve your needs effectively. ·A heavy-duty base plate system is supplied; and can be bolted to any style of base system. ·Carefully following Steps #1 and #2 makes the remaining Round Top Shelter assembly easy and safe.
PAGE 3
ASSEMBLY OF FRAMEWORK 2 people assisting with framework assembly makes the task easier and safer. CAUTION! The Storage Solutions™ Round Top Shelter frame design is flexible. Please be aware that overhead parts and/or pipes can come loose and fall during assembly. DO NOT allow children on or around the assembly site when erecting your shelter. And ALWAYS pay attention overhead for safety! Assembly using 3 curved pipe male/female (A), and 1 curved pipe male/male (B), along with long connector bolt (C).
PAGE 4
Unfold the roof skin and lay it next to the bottom purlin on one side of your shelter. Center the roof skin so approximately 6” of material extends beyond both ends of the framework. Using the supplied lacing rope, lace the bottom edge of the roof skin through the reinforced grommets to the bottom purlin. Begin lacing in the middle of the skin. Once you reach the ends, tie off lacing on end base plates. LACING THE GROMMETS TOO TIGHTLY CAN DAMAGE THE COVER.
PAGE 5
Congratulations! You now have a completed high-quality Weatherguard™ Commercial Greenhouse. ONE LAST HINT! If you ever disassemble your Weatherguard™ Commercial Greenhouse, clean and dry the skin completely before storing to prevent mildew, which can rot the polyethylene. Always use caution when disassembling overhead framework! All of us at Jewett-Cameron thank you for purchasing our products.
PAGE 6
PLEASE READ THIS WARRANTY CAREFULLY TO INSURE YOUR RIGHTS LIMITED EXPRESS WARRANTY Jewett-Cameron warranties your Storage Solutions™ Shelter to be free of defects in material and workmanship and Further warrants that, in normal use, the Storage Solutions™ Shelter is waterproof, will not tear, and will not be affected by mildew. This warranty is extended to the first retail purchaser of the Shelter for consumer use, and lasts for one (1) year from the date of purchase.