Product Manual

WeatherHawk®

Toll free in USA: 866-670-5982, International: 435-227-9802, FAX: 435-227-9749 Printed 2013

5. Start application software and monitor the sensor displays. Within a couple of minutes, numerical values

should appear confirming that the WeatherHawk is functioning. The lights labeled Scan/Receive on the underside

of the station should also blink every ten seconds.

If the WeatherHawk does not function properly, contact WeatherHawk Customer Service to solve the

problem before continuing to the next steps.

6. Using your PC and weather station software, enter the setup parameters for the station. If you are using

WeatherHawk PRO software, see the section in this document labeled “Station Setup usingWeatherHawk

Pro Software”. If you are using other software, please refer to the software manual for that software.

7. Disconnect the serial cable from the WeatherHawk and place the dust cover back on the serial port.

8. If your WeatherHawk is wireless (Model 916/922/240), setup the radio (see “Radio Setup” section below).

9. Install the WeatherHawk weather station at the site. Refer to the Installation Guide provided on the CD

shipped with your station for siting information and installation procedures.

Station Setup Using WeatherHawk PRO Software

1. Click on the This Station menu and choose Setup from the drop down menu (Figure 4a and 4b).

2. Select Direct Connection from the setup screen and select the Serial Port on your computer which the

serial cable is connected to. (Figure 5). If necessary, click the Change button next to the Serial PortI to

select a different port.

Figure 4a

Figure 4b