Instructions / Assembly

WINDOW
INSTALLATION INSTRUCTIONS
*READ CAREFULLY BEFORE INSTALLING
1
Do NOT remove the plastic band from window until
instructed to do so (applies only to Two-Track models).
Position window into opening or against trim to check for a
proper fit.
Remove the storm window and caulk the existing window
where the storm window will be mounted (caulk the head
and jambs only!). *To allow for good drainage, do NOT
caulk the sill.
Position the storm window into the opening or against trim,
“squaring up” the unit. Then install the screws provided into
pre-punched holes of the window flange. Do
NOT
overtighten the screws or you may crush down the flange.
NOTE: If unit has expander adjust expander so that it
makes even contact across bottom of existing window sill.
Remove plastic band (applies only to Two-Track models).
8020064 7/07
2
3
4
If your window is too large it can be trimmed down to fit as follows:
There are score grooves provided on the window flange. Decide on
the amount of flange to be trimmed. Score the flange in the grooves
with a utility knife. Bend flange back and forth with a pliers until it
breaks off.
BLIND STOP
SURFACE
OPENING WIDTH
BLIND STOP
SURFACE
CAULK
HEAD
JAMB JAMB
OPENING
HEIGHT
SILL
CAULK
BLIND STOP INSTALLATION
3-TRACK UNIT SHOWN
OPENING
HEIGHT
OVERLAP
TRIM
CAULK
HEAD
SILL
OVERLAP
OPENING WIDTH
TRIM
CAULK
JAMB
JAMB
OVERLAP INSTALLATION
3-TRACK UNIT SHOWN
5