Instructions / Assembly

weatherstrong.com 888-745-0004
11
Matching Ends and Island Back Panels
MatchingEndPanelsandIslandBackPanelsareusedtocoveranyexposedcabinetsidesorbacks.
These panels are manufactured from the same material as the cabinet doors and drawer fronts.
Matching End Panels are oversized and will not match the exact measurements of your cabinets.
Thisallowsthemtobetrimmedtofollowthepitchoftheoorofyouroutdoorspace,whichisoftensloped.
MatchingPanelsshouldbetrimmedtotafterthecabinetsarepermanentlysetandleveled.
Panel Installation:
1.Refertoyouroorplanorcabinetlayouttodeterminewhichpanelsgoinwhichlocation.
2.Measureeachpanellocationfromfronttobackandtoptobottom.Usethesemeasurementstomark
your panel.
3. Once the panel is marked, use a table saw or circular saw to trim the panel to size.
4.UseC-clampsorQuick-Gripstoholdthepanelinplaceduringinstallation.
a. Screws (WSSS1.25-Screw Kit) or Contractor adhesive can be used to secure the panels to the cabinets.
 b.IfusingScrewsmakesuretodrillpilotholesintothecabinetbeforeplacingthepermanentscrew.
Please Note: Panels that will cover the side of a cabinet with a Bar Riser Kit attached will need to have the
proleofthesideofthecabinetcombinationcutout.
Matching Ends and Island Back Panels
Panel as shipped
Panel after cutting on
job site without heat
component
Panel after cutting
on job site with heat
component