Installation Guide
weatherstrong.com 888-745-0004
Matching Ends and Island Back Panels
MatchingEndPanelsandIslandBackPanelsareusedtocoveranyexposedcabinetsidesorbacks.These
panels are manufactured from the same material as the cabinet doors and drawer fronts.
Matching End Panels are oversized and will not match the exact measurements of your cabinets. This allows
themtobetrimmedtofollowthepitchoftheoorofyouroutdoorspace,whichisoftensloped.
MatchingPanelsshouldbetrimmedtotafterthecabinetsarepermanentlysetandleveled.
Panel Installation:
1.Refertoyouroorplanorcabinetlayouttodeterminewhichpanelsgoinwhichlocation.
2.Measureeachpanellocationfromfronttobackandtoptobottom.Usethesemeasurementstomarkyour
panel.
3. Once the panel is marked, use a table saw or circular saw to trim the panel to size.
4.UseC-clampsorQuick-Gripstoholdthepanelinplaceduringinstallation.
a. Screws (WSSS1.25-Screwkit) or Contractor adhesive can be used to secure the panels to the
cabinets.
b.IfusingScrewsmakesuretodrillpilotholesintothecabinetbeforeplacingthepermanentscrew.
Please Note: Panels that will cover the side of a cabinet with a Bar Riser Kit attached will need to have the
proleofthesideofthecabinetcombinationcutout.
Need to label as panel as shipped and panel after cutting on job site or something similar.
Matching Ends and Island Back Panels
Panel as shipped Panel after cutting on
job site