Installation Guide

weatherstrong.com 888-745-0004
1. Each Wall Cabinet requires 4 wall anchors (2 top, 2 bottom)
2. Screws should be placed in each corner approximately 2” from the end panels.
3. Pre-drill the pilot holes before you place the cabinet against the wall, with a standard 3/16” drill bit.
4.Thenputthecabinetinplace.Ineachcornerusethe3/16”Tapconbitthruthepilotholestocreatestarter
holes into the concrete block, for the Tapcon anchors.
5. Remove the cabinet to complete drilling the pilot holes into the concrete block. When complete, place the
cabinet against the wall.
6.Onceyouconrmthecabinetislevelandsquare,useTapcon®410StainlessSteel3/16”x2-3/4”
fasteners, with a ¼ stainless steel washer to secure the cabinet to the wall.
Anchoring to Concrete Block Walls
2”
inch
3
16
drill bit.
inch
3
16
3
2
4
x
inch Washer
1
4