Owner manual

License Plate Frame Mounting Instructions
TOOLS NEEDED • #2 Phillips Head Screwdriver • 7/16" Wrench
HELP!
If you have questions regarding installation of this or any
other WeatherTech
®
product, please call our customer service
department at [phone], Monday through Friday, 9 a.m.
to 5 p.m. Central Time. We want to help you get the most out
of your new WeatherTech
®
product.
PLEASE CHECK STATE AND LOCAL LAWS PRIOR TO USE.
Proudly Designed,
Engineered, and
Manufactured
in the USA.
High Quality Stainless Steel
Universal Fastener Kit*
© 2014 by MacNeil IP LLC
Acura, AM General, Audi, BMW, Buick,
Cadillac, Chevrolet, Chrysler, GMC,
Daewoo, Dodge (except Viper), Ferrari,
Ford, Honda, Hummer, Hyundai, Isuzu,
Infiniti, Jaguar, Jeep, Kia, Land Rover,
Lexus, Lincoln, Mazda, Mercedes-
Benz
®
, Mitsubishi, Nissan, Oldsmobile,
Pontiac, Porsche
®
, Range Rover, Saab,
Saturn, Scion, Subaru, Suzuki, Toyota,
Volkswagen, Volvo
FITS THESE MODELS AND MORE:
CARE INSTRUCTIONS:
• Clean with soapy water or window cleaner
• Do not use abrasive pads, harsh detergents
or degreasers on the PlateFrame
®
Specialist In Original Equipment and
Aftermarket Automotive Accessories
CONTENTS:
• PlateFrame
®
Plastic Frame
• Stainless Steel Universal Fastener Kit
• Click and Stay
™
Screw Caps
PlateFrame
®
1. Remove the Click and Stay
™
screw caps from the
mounting holes in the WeatherTech
®
PlateFrame
®
by pushing them out from the back side.
2. Lay the WeatherTech
®
PlateFrame
®
face down on
a soft or non-abrasive surface.
3. Position the license plate face down onto
PlateFrame
®
, lining up the holes in the plate and
the holes in the frame. Make certain that you have
a proper fit between the license plate and the
PlateFrame
®
.
4. Select the four mounting screws that are most
appropriate for your vehicle (If your mounting
location only uses 2 holes, then see step 4A FIRST).
Carefully position your PlateFrame
®
license plate
assembly into place on your vehicle and using a #2
Phillips Head screwdriver, securely fasten with the
screws you have chosen, BEING CAREFUL NOT
TO OVER-TIGHTEN.
(4A) If the mounting location on your vehicle only
uses two screws, then first select machine screws
and matching nuts from the hardware pack. Install
these two screws through the PlateFrame
®
license
plate assembly in the holes that DO NOT go to
the mounting holes on the vehicle. Using a #2
Phillips Head screwdriver and a wrench, tighten
the two nuts onto the end of each screw, locking
the assembly together, BEING CAREFUL NOT TO
OVER-TIGHTEN.
5. Finally, position the Click and Stay
™
screw caps
over each screw on your PlateFrame
®
with the drain
hole on the bottom and push firmly to snap each
one into place.
*
Some vehicle
models may require
re-use of existing
fasteners
For joining cover
& plate without
mounting holes