Owner's manual

License Plate Frame Mounting Instructions
TOOLS NEEDED • #2 Phillips Head Screwdriver • 7/16" Wrench
Acura, AM General, Audi, BMW, Buick,
Cadillac, Chevrolet, Chrysler, GMC,
Daewoo, Dodge (except Viper), Ferrari,
Ford, Honda, Hummer, Hyundai, Isuzu,
Infiniti, Jaguar, Jeep, Kia, Land Rover,
Lexus, Lincoln, Mazda, Mercedes-
Benz
®
, Mitsubishi, Nissan, Oldsmobile,
Pontiac, Porsche
®
, Range Rover, Saab,
Saturn, Scion, Subaru, Suzuki, Toyota,
Volkswagen, Volvo and More!
FITS THESE MODELS AND MORE:
CARE INSTRUCTIONS:
• Clean with soapy water or window cleaner
• Do not use abrasive pads, harsh detergents
or degreasers on the StainlessFrame
Specialist In Original Equipment and
Aftermarket Automotive Accessories
CONTENTS:
• StainlessFrame License Plate Cover
• (4) Acessory Chrome Caps
• (4) Cap Anchors
• PlateSpacer
™
StainlessFrame
PlateSpacer
™
StainlessFrame
PlateSpacer
™
Cap Anchor
Chrome Cap
FIGURE 1
StainlessFrame
Proudly Designed,
Engineered, and
Manufactured
in the USA.
© 2014 by MacNeil IP LLC
HELP!
If you have questions regarding installation of this or any
other WeatherTech
®
product, please call our customer service
department at [phone], Monday through Friday, 9 a.m.
to 5 p.m. Central Time. We want to help you get the most out
of your new WeatherTech
®
product.
PLEASE CHECK STATE AND LOCAL LAWS PRIOR TO USE.
1. Unscrew the license plate frame from the vehicle and
keep existing screws together as you will use them to
mount the StainlessFrame.
2. Lay the StainlessFrame face down on a soft or non-
abrasive surface.
3. The bottom of the StainlessFrame is the edge with the
(2) metal tabs. Place the bottom of your license plate
under these (2) tabs.
4. Place the included PlateSpacer
™
onto the back of the
license plate by lining it up to the four holes.
5. Provided in the parts kit are (4) cap anchors and
(4) chrome caps. Place the cap anchors under the
screws previously removed see FIGURE 1.
6. Pick up the assembly, with the holes still aligned, and
place the screws into the top two holes to help hold
the assembly together.
7. Loosely attach all screws and cap anchors on your
vehicle. Tighten all screws after alignment.
8. After tightening, snap the (4) chrome caps on the top
of the screws.