User Manual

License Plate Frame Mounting Instructions
TOOLS NEEDED • #2 Phillips Head Screwdriver • 7/16" Wrench
High Quality Stainless Steel
Universal Fastener Kit*
Acura, AM General, Audi, BMW, Buick,
Cadillac, Chevrolet, Chrysler, GMC,
Daewoo, Dodge (except Viper), Ferrari,
Ford, Honda, Hummer, Hyundai, Isuzu,
Infiniti, Jaguar, Jeep, Kia, Land Rover,
Lexus, Lincoln, Mazda, Mercedes-
Benz®, Mitsubishi, Nissan, Oldsmobile,
Pontiac, Porsche®, Range Rover, Saab,
Saturn, Scion, Subaru, Suzuki, Toyota,
Volkswagen, Volvo
FITS THESE MODELS AND MORE:
CARE INSTRUCTIONS:
• Clean with soapy water or window cleaner
• Do not use abrasive pads, harsh detergents
or degreasers on the Billet License Plate
Frame
Specialist In Original Equipment and
Aftermarket Automotive Accessories
CONTENTS:
• Billet License Plate Frame
• Stainless Steel Universal Fastener Kit
• Click and Stay™ Screw Caps
1. Select the four mounting screws that are most
appropriate for your vehicle (If your mounting location
only uses 2 holes, then see step 1A FIRST). Carefully
position your license plate assembly into place on
your vehicle and using a #2 Phillips Head Screwdriver,
securely fasten with the screws you have chosen,
BEING CAREFUL NOT TO OVER-TIGHTEN.
(1A) If the mounting location on your vehicle only uses
two screws, then first select machine screws and
matching nuts from the hardware pack. Install these two
screws through the license plate assembly in the holes
that DO NOT go to the mounting holes on the vehicle.
Using a #2 Phillips Head screwdriver and a wrench,
tighten the two nuts onto the end of each screw,
locking the assembly together, BEING CAREFUL NOT
TO OVER-TIGHTEN. 2. Lay the WeatherTech® Billet
License Plate Frame face down on a soft or non-
abrasive surface.
2. Finally, position the Click and Stay™ screw caps over
each screw on your license plate frame with the drain
hole on the bottom and push firmly to snap each one
into place.
* Some vehicle
models may require
re-use of existing
fasteners
For joining cover
& plate without
mounting holes
Billet License Plate Frame
Proudly Designed,
Engineered, and
Manufactured
in the USA.
© 2014 by MacNeil IP LLC
HELP!
If you have questions regarding installation of this or any
other WeatherTech
®
product, please call our customer service
department at [phone], Monday through Friday, 9 a.m.
to 5 p.m. Central Time. We want to help you get the most out
of your new WeatherTech
®
product.
PLEASE CHECK STATE AND LOCAL LAWS PRIOR TO USE.