User guide

Questions? Call customer service @ 630.769.1500
Monday thru Friday, 9 a.m. to 5 p.m. Central Time.
MF004
Thank you for purchasing the WeatherTech
®
No-Drill MudFlap. Please read this installation guide to
thoroughly familiarize yourself with the steps to install the MudFlap on your vehicle. When properly installed,
the WeatherTech
®
No-Drill MudFlap will provide you with years of protection.
MudFlap
Tools Needed
You need one of the tools pictured here to
complete the installation.
Hardware Included
Your MudFlap kit includes an Allen Wrench
and the plastic push rivets pictured here.
Installation Instructions
Allen Wrench
Plastic
Rivets
Ratchet & SAE
Socket Set
SAE Hex head
nut driver Set
Start by thoroughly washing your vehicle. Take
care to remove all dirt, debris, and stains from
each fender in the areas corresponding to where
the MudFlaps will be installed.
Begin driver's side MudFlap installation by
parking the vehicle on level ground with wheels
turned fully to the left.
Remove the hex-head screw located in the position
indicated in the photo. Do not lose this screw, as you
will need it to complete the MudFlap installation.
Identify the driver's side MudFlap by locating the
“LH” mark located centrally in the recessed
cavity on the tire side of the MudFlap. Ensure that the
QuickTurn
™
fastener is in the fully unlocked position
using the Allen wrench provided.
3
3
4
4
1
1
2
2
The MudFlap is designed to
fit vehicles with standard size
wheels and tires. Installation
of mud flaps on vehicles with
aftermarket wheels or oversize
tires may interfere with the
MudFlap and will void the
warranty and may damage the
MudFlap or the vehicle.
WARNING!
Unlocked Position