User's Manual

11
INSTRUCTION MANUAL
5.1.7 Transmitter module for Graupner MC19/MC22/MC22S transmitters
Unscrew the original 35 MHz antenna and replace it with the adapter stalk. Remove the back plate and disconnect the blue plug which goes into
the original HF module. This plug is now inserted into the weatronic module adapter which is then fixed to the transmitter’s main circuit board in the
position shown on the picture below using double sided sticky tape. The plastic visibility window on the casing should now be removed to allow you
to route the connecting cable out of the casing, or, alternatively the cable may be fed out via a free external switch hole.
Weatronic adapter module fitted to a Graupner Weatronic transmitter module fitted to a MC 19S transmitter
MC19S/MC22S transmitter
5.1.8 Transmitter module for Multiplex Evo/Royal Evo Pro 7/9/12 transmitters
Remove the original pole antenna from its housing and open the casing. Plug the special connector cable which is supplied fitted to the adapter stalk
into the transmitter module ensuring that it is correctly seated.
The connecting cable for the EVO transmitter is fed down through The weatronic adapter module replaces the original Multiplex HF module
the antenna tube.
Guide the connecting cable down through the antenna tube into the inside of the transmitter and plug it into the free socket on the weatronic adapter
module. Remove the original HF module and replace it with the weatronic adapter module. The casing may now be replaced and the adapter stalk
pushed into place where it is retained by an ‘O’ ring. Fit the transmitter module to the stalk ensuring that the LEDs are visible when viewed from the
front.