User's Manual

11
DUAL RECEIVER micro
Dual Receiver 2.4 Dual FHSS micro 12 (left), 12 channel transmitter module (right)
6.3 Binding of transmitter and Dual Receiver
A weatronic transmitter module may be bound to number of receivers. The transmitter module transmits with a coded sequence (several million
possibilities), that have to be accepted by the receiver. A simultaneous use of several weatronic receivers is not possible. (Transceiver conflict)
The weatronic 2.4 Dual FHSS receivers have to be bound to a transmitter/ transmitter module before it can be used. During this binding procedure,
the receiver stores the transmitter serial no as well as the transmitter is storing the receiver serial no. This binding procedure only needs to be done
once. After that the receiver will only listen to that one transmitter. The procedure of Binding is easy and is done as follows:
The transmitter module has two micro switches that are „BUTTON 1“ and „BUTTON 2“ indicated on the front side of the transmitter module. For
safety reasons, these buttons are hot only for a limited time. This is indicated when turning on the module by flashing all three LED’s once.
• BUTTON 1 activates the range check.
• BUTTON 2 is used for binding and quickbinding.
Please take care of a distance between transmitter and receiver of at least half a meter. Turn on the transmitter and choose a PPM modulation. Turn
off and on again and immediately after that press the button 2 until the green LED flashes steadily. Then turn on the Dual Receiver 2.4 Dual FHSS
micro, insert the red jumper on the back side of the receiver into the top position, connecting the yellow and red pins.
As soon as the transmitter and receiver are bound to each other, this will be indicated by a solid green LED light, both on the transmitter module and
the receiver. After that, remove the red jumper from the back side of the receiver and store in a safe place.
6.4 Use of micro SD card
The use of a micro SD card is not necessary for the function of the weatronic system but very useful. All flight and operation data are stored on this
card located in the transmitter module. Install the card on the side of the transmitter module with the connectors on the upper side. You may read out
the flight data by means of our GIGAControl software (www.weatronic.com or www.weatronic-usa.com).
6.5 Quickbinding
The transmitter module will recognize all receivers that were ever bound to it. When switching from one receiver (RC-model) to a different one, the
transmitter has to be quick-bound to this other receiver. This is achieved easily. After turning on the transmitter and receiver, just press the Button 2
for a short time and the status LED (green) will indicate quick-binding by turning on solid.
6.6 Servos and power supplies
The Dual Receiver 2.4 Dual FHSS micros have several options, depending on the receiver type. The coding of the pins is as follows
(viewed from front):
• Top: signal
• Middle: plus
• Bottom: minus
The 8 and 10 channel versions of the micro receivers have additional plug sots for the battery / power. The 12 channel version has to be powered
through a V-cable which can be plugged in at any position. There are several option for the power supply: