User's Manual

7
DUAL RECEIVER micro
The patch cable of the EVO transmitter is routed through the original telescoping rod antenna tube
Route the patch cable harness through the original antenna tube to the inside of the transmitter and attach it to the transmitter module adapter.
Remove the original Multiplex HF-module. Insert the weatronic module at the place of the removed Multiplex HF-module. Double check, that all
connections are solid. Return the back cover of the transmitter. Finally insert the disc receiver into the position of the antenna and slide the transmitter
module onto its disc.
5.1.2 Transmitter module for Multiplex Profi 4000/3030/3010
Remove the telescopic 35/72 MHz rod antenna and screw on the mounting disc. Remove the base plate of the transmitter and remove the original
35/72MHz module from its slot. Remove the see through window from the back plate or drill a hole on the front bottom of the cover, or route the
cable through one of the not used switch slots on the top side of the transmitter.
weatronic 2.4 Dual FHSS transmitter module installed on Multiplex Profi MC 4000
Adapter-printboard and patch cable for Multiplex Profi MC 3030/4000- series and EVO Royal/ Royal Pro 7/9/12
Insert the weatronic patch cable into the weatronic transmitter module and make sure that the snap locks it into place. Place the transmitter module
on the mounting disc and route the other end of the cable through the slot in the lid. You can also route the cable through one of the unused switch
positions on the top of the transmitter. Then attach the free end of the patch cable to the adapter board again making sure the snap engages to
secure the cable to the board. Finally put the adapter board into the same spot as the HF-module (see picture) and reattach the lid. The installation
is completed and the transmitter is ready for operation.