User's Manual

5.1.3 Transmitter module for Graupner MC 24

Remove the telescope antenna and remove the bottom lid of the transmitter. Replace the original HF-module with the weatronic 2.4 GHz module.

Screw the adapter disc into the antenna position. Either remove the clear plastic window from the bottom lid or route the cable through one of the

free switch holes on the top side of the transmitter. Make sure that both ends of the patch cable are secured by the snap hook. Close the lid and you

are ready to go.

5.1.4 Transmitter module for Graupner MX 22/JR 9X/JR10X/MX24S/JR 12X

weatronic 2.4 Dual FHSS transmitter module on Graupner/JR transmitter MX22

Remove the telescopic antenna and the original HF-module. Screw in the adapter disc in the position of the old antenna. Insert the weatronic adapter

module in place of the old HF-module. As a last step, connect the adapter module with the patch cable to the weatronic transmitter module. Make

sure that both ends snap in and place the transmitter module on the mounting disc with the LED lights facing up to the operator.

Adapter ﬁtting Graupner MX22/JR9X/JR10X, right adapter module for JR/Graupner

5.1.5 Transmitter module for Graupner MC19/MC22/MC22S

Remove the existing 35 MHz- telescopic antenna and replace with the adapter provided with the weatronic system. Remove the bottom lid of

the transmitter and disconnect the 4-wire blue colored connector from the original HF-module. Then insert this blue connector into the weatronic

transmitter adapter and mount the weatronic adapter module circuit board with double sided tape in the position as shown in the picture below. Either

remove the clear window in the lid to route the patch cable through, or use one of the unused switch locations on the top side of the receiver.