User`s guide

Web Mountain Technologies Page 26
Triggers
This page allows the user to setup simple IF – THEN actions based upon
receiving a particular command, serial string, time of day, or other events. Some
examples would be IF <UPB received> THEN send another UPB command with
or without a delay, or IF <UPB received> THEN send an email.
In addition, the user can setup a Scheduled event from this page or cause a
received signal from one protocol to trigger sending a command to another
protocol. This is also how you setup Buttons for the embedded Control Panel.
NOTE: IF-THEN type UPB Triggers will not function if there is a Remote session
(using UPStart or some other remote access software) in progress. Scheduled
events will function at all times, even if a Remote session is in progress.
NOTE: The RUC will not trigger on a command it has sent unless the Echo
selection on that COM port is set to YES on the Device Configuration page.