User`s guide

Web Mountain Technologies Page 29
To setup a UPB Link as the trigger event, select UPB Link from the dropdown selection, then
either enter in the serial string command as generated by the UPB command wizard, or enter
in your desired NID, LID (Link ID), and select your command from the dropdown, as shown
below. Again, do not enter in the start character (Control-T) or the terminating character (CR).
Notice that UPB Direct Commands and UPB Link Commands are the same – the only difference
is the DID vs the LID. DIDs operate on one unit while LIDs operate on all devices associated
with that link.
To setup a Zwave command as the trigger event, select Zwave from the dropdown, then enter in
the serial string command as desired, as shown below. Do not enter in the start character (<)
or the terminating character (Carriage Return).