User`s guide

Web Mountain Technologies Page 46
^ - used to enter raw hex codes, for example ^02 means hex code 0x02.
^00 – don’t send a Carriage Return if this is the last “character” in the string. If not the last
character in the string, send 0x00.
|| Ignore a carriage return in between two commands
+ - at the start of a serial string tells the RUC to add a small intracharacter delay between each
character of a serial string (needed to send Insteon commands through a 2412 or 2413S
Insteon powerline interface module).
Sending a text message from a trigger.
You can cause a text message to be sent from a trigger by using the Send Email function. To
send a text, use these email addresses (you will need to know the carrier of the recipients cell
phone service):
Carrier
email Address
AT&T
[e-mail]
Verizon
[e-mail]
Sprint
[e-mail]
T-Mobile
[e-mail]
Nextel
[e-mail]
Cingular
[e-mail]
Alltel
[e-mail] OR
[e-mail]
CellularOne
[e-mail]
Virgin Mobile
[e-mail]
Omnipoint
[e-mail]
Qwest
[e-mail]
New Feature only in V4 devices - Allow wild cards in UPB triggers.
1. Allow wild cards in UPB triggers. In NID, DID/LID and command fields for both receive
and send sides, allow * as an option. Proceed as follows:
a. If the Receive trigger is a Direct type, only match incoming commands that are
direct types. If the Receive trigger definition is a Link type, only match incoming
commands that are link types.
b. If Receive NID = xx and Send NID=yy, then send with a NID of yy.
c. If Receive NID=xx and Send NID=*, then send the NID (xx) for any incoming
command that is matched.