Installation Guide

ManualsBrandsWebasto ManualsAlternative Energy Solutions32 Amp Level 2 Plug-In EV Charging Station with 25 ft. Charge Cable

IT IS RECOMMEND THAT A LICENSED ELECTRICIAN INSTALL

THE ELECTRICAL SERVICE AND THE CHARGING STATION.

Model Plug-in EVSE-RS not for outdoor installation

NOTICE TO ELECTRICIAN: Leave this Installation Guide with the EVSE-RS Plug-in customer for future reference.

AeroVironment EV Solutions™ EVSE-RS Plug-in Charging Station

INSTALLATION GUIDE

Summary of content (4 pages)

PAGE 1
I N S TALL ATI ON GU I D E AeroVironment EV Solutions™ EVSE-RS Plug-in Charging Station IT IS RECOMMEND THAT A LICENSED ELECTRICIAN INSTALL THE ELECTRICAL SERVICE AND THE CHARGING STATION. Model Plug-in EVSE-RS not for outdoor installation NOTICE TO ELECTRICIAN: Leave this Installation Guide with the EVSE-RS Plug-in customer for future reference.
PAGE 2
INSTALLATION STEPS 1 2 wall stud 45 in. (114.3 cm) to floor (A) Use Stud Finder to locate wall stud. Mark the center point of the wall stud. 3 45 in. to floor Measure and mark a point on the wall stud 45 inches from the floor. 4 CHARGER MOUNTING DRILL .234 DIA X 2.00 DEEP INTO CENTERLINE OF STUD A APPROXIMATELY 17 INCHES Detail of template Use Level to straighten Installation Template. Pin Installation Template to the “center point mark” (Point A). Tape Template in place.
PAGE 3
5 STUD CENTERLINE CHARGER MOUNTING 6 Drill holes for Mounting Plate using a 1/4 inch drill bit. in 2 places on centerline of stud 3.345 INCHES A 45 INCHES TO FLOOR Drill holes for Cable Hanger using 1 /8 inch drill bit in 2 places Drill holes in Cable Hanger using 7/32 inch drill bit in 2 places. 7 Postiion the station with the mounting bosses inserted into the corresponding openings in the plate. Slide Charging Station down onto Mounting Plate to latch into place.
PAGE 4
PACK AG I NG CO NTE NT S CHARGING STATION QUICK START GUIDE INSTALLATION GUIDE HARDWARE KIT HARDWARE KIT CONTENTS CABLE HANGER 1 - Mounting Plate 2 - 3/8 inch x 2½ inch Lag Bolts 2 - 3/8 inch Flat Washers INSTALLATION TEMPLATE TOO L S 2 - #8 x 2½ inch Painted Head Wood Screws (not included) 1. Electronic Stud Finder 2. Drill 3. 1 4. 7 5. 1 6. Carpenter’s Level 7. 9 8. #2 Phillips Screwdriver 9. Measuring Tape 10. Masking Tape 11.