Technical data

A gasket (Fig. 4) must be fitted between heater and car

body. The gasket must be renewed prior to each re-

installation

. The support surface for the heater mounting

foot must be level. A special tool is available from the

manufacturer for drilling the holes and levelling the support

surface, if necessary. Surface irregularities of up to max.

1 mm can be compensated for by means of the gasket.

CAUTION:

After the installation has been performed, a check must be

carried out to verify that no part of the housing is in contact

with any surrounding parts. Non-compliance could result in

a blockage of the heater fan.

Name Plate

The type plate must be located at a place where it is pro-

tected against damage and be easily accessible once the

heater has been installed (or else, a type plate duplicate is

to be used).

The years not applicable are to be removed from the type

plate.

Fig. 3: Hole Pattern

Fig. 4: Gasket

Unobstructed installation to be ensured!

Fig. 5: Installation

Fig. 6: Name Plate

Air Top 2000 S