Operating instructions

ManualsBrandsWebasto ManualsAir CompressorAir Top 2000 S D

Dear Webasto Customer,

Thank you for choosing the Webasto Air Top 2000 ST air heater.

The Air Top 2000 ST heater is used

– to heat cabins, boats, trucks, minibuses, vans and motorhomes and

– to defrost vehicle windows.

We presume that the principle and mode of operation of your new heater has

been explained to your complete satisfaction by the workshop/service centre

which installed the heater. In these operating instructions we would like to

once again provide you with an overview of the safe use of the Air Top 2000

ST heater.

Repair or maintenance work not described here may only be carried out by an

authorised Webasto dealer.

1. Within the territory governed by European Directive 70/156/EEC and/or EC/2007/46 (for

new vehicle types from 29/04/2009), there are homologation approvals for the Air Top

2000 ST air heaters in accordance with the ECE-R 122 (Heating) and ECE-R 10 (EMC).

NOTE:

The specifications of this Directive are binding in the scope of the Basic Directive

EEC/70/156 and/or EC/2007/46 (for new vehicle models from 29/04/2009) and

should also be observed in countries in which no special regulations exist.

2. The year in which the heater was used for the first time must be permanently displayed

on the factory plate by deleting the inapplicable years from the plate.

3. The heaters are not designed for heating hazardous substance transport

compartments.

To install the Air Top 2000 ST D heater unit in hazchem vehicles, the requirements of the

Directive ECE-R 122 must be met.

4. Claims can only be made if it can be verified that the claimant has complied with the

servicing and safety instructions.

5. The heater must be switched off at filling stations and tank farms as a result of

the risk of explosion.

6. The heater may not be operated in enclosed spaces (such as garages) as a result

of the risk of poisoning and asphyxiation, even if a timer or Telestart remote is

used.

7. The heater must be checked by an expert at the latest at the start of the cold weather

period.

Introduction

Servicing and safety instructions

Operating Instructions

Air Top 2000 ST

9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 1 Thursday, June 6, 2013 8:25 AM

Summary of content (8 pages)

PAGE 1
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 1 Thursday, June 6, 2013 8:25 AM Operating Instructions Air Top 2000 ST Introduction Dear Webasto Customer, Thank you for choosing the Webasto Air Top 2000 ST air heater. The Air Top 2000 ST heater is used – to heat cabins, boats, trucks, minibuses, vans and motorhomes and – to defrost vehicle windows.
PAGE 2
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 2 Thursday, June 6, 2013 8:25 AM 8. In the event of long-lasting heavy smoke development, unusual combustion noises or a smell of fuel or if the heater suffers continuous fault cut-outs with error messages (flashing code), it must be shut down by removing the fuse and must not be reused until it has been inspected by Webasto-trained personnel. 9.
PAGE 3
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 3 Thursday, June 6, 2013 8:25 AM Control element Changes to the settings on the control element will be carried out with a time delay Rotary knob for: - Switching on and off - Setting the room temperature - Resetting after a fault cut-out Indicator/error code display Switch on Set the rotary knob on the control element to the desired temperature.
PAGE 4
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 4 Thursday, June 6, 2013 8:25 AM Combination timer Combination timer Indicator Temperature selector Day Program number MO 2 Time Program selector Immediate heat Return Forward General information The combination timer allows the heater start time to be selected for a period of up to seven days. Three cut-in times can be programmed, although only one of them may be activated. The combination timer has a temperature setpoint generator.
PAGE 5
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 5 Thursday, June 6, 2013 8:25 AM Switch on Manual: Press the button (continuous heating mode) Automatic: By programming the start time Switch off Manual: Press the button again Automatic: By programming the operating period When heater unit is running: By setting the remaining time Set time/date Press the button for more than two seconds - the time flashes set the time using the and buttons - the day flashes - set the day.
PAGE 6
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 6 Thursday, June 6, 2013 8:25 AM Actions in event of faults If an error occurs, first check the fuse and plug connections to ensure that they are in proper condition and connected correctly. If the actions described below do not rectify the error, have the heater checked by Webastotrained personnel.
PAGE 7
9010302E_Operating_Instructions_Air_Top_2000_ST_EN.fm Page 7 Thursday, June 6, 2013 8:25 AM Error code output on combination timer or control element If the system is fitted with a combination timer, when an error occurs an error code is output on the timer's display until the heater has been rectified. The error code is output if the heater is fitted with a control element after an error has occurred by the switch-on indicator/error code indicator flashing.
PAGE 8
Webasto Thermo & Comfort SE Postfach 1410 82199 Gilching Germany Visitors' address: Friedrichshafener Str. 9 82205 Gilching Germany Internet: www.webasto.com The telephone number of each country can be found in the Webasto service center leaflet or the website of the respective Webasto representative of your country. Part No. 9010302E • 05/13 • Modifications and errors excepted • Printed in Germany • © Webasto Thermo & Comfort SE, 2013 9010302E_Operating_Instructions_Air_Top_2000_ST_EN.