Unit installation

VW T5

Fuel Connection

CAUTION!

Open the vehicle's fuel tank cap, ventilate the tank and then re-close the tank lock.

Catch any fuel running off with an appropriate container.

Install fuel line and metering-pump wiring harness so that they are protected against stone impact. Un-

less specified otherwise, always fasten using cable ties.

Mount the fuel line and wiring harness with rub protection on sharp edges.

WARNING!

The fuel line and wiring harness are routed to the metering pump in as shown in the wiring harness

routing diagram.

Complete connector with single wire seal

[2x], tab connector and connector housing on

wire of metering pump from heater unit and

connect to wiring harness of metering pump.

1 Plug connection on wiring harness of me-

tering pump

Connect-

ing wiring

harness of

metering

pump

Cut heat protection hose as shown in Figure

12 and 13. Pull wiring harness of power sup-

ply and wiring harness of metering pump and

Mecanyl fuel line into one heat protection

hose each.

1 Wiring harness of power supply in heat

protection hose

2 Mecanyl fuel line and wiring harness of

metering pump in heat protection hose

3 Cable tie

Installing

lines

Route wiring harness of power supply and

wiring harness of metering pump and Mecan-

yl fuel line over heat guard plate on left-hand

side of vehicle. Route wiring harness of pow-

er supply further to battery.

4 Wiring harness of power supply in heat

protection hose

2 Mecanyl fuel line and wiring harness of

metering pump in heat protection hose

3 Wiring harness of power supply

1 Cable tie

Installing

lines