Unit installation

8
VW T5
Preparing heater unit
With fresh-air mode, an underride protection
as shown in Figure 33 must be installed if not
present!
1 Heater unit
2 Mount base seal
3 Protective grill
Preparing
heater unit
Cut approx. 360 mm off 60 mm dia. flexible
tube.
3 Heater unit
4 Wiring harness
1 60 mm dia. flexible pipe, 360 mm long
2 50-70 mm dia. hose clamp
Premount-
ing heater
unit
Route through wire of metering pump 4
downward.
Fasten hot-air flexible tube on bracket with
cable tie.
1 Bracket
2 Large diameter washer, spring lockwasher,
M6 nut [4x each]
3 Mount edge protection, 70 mm long [2x]
5 Cable tie
Installing
bracket
1 Exhaust pipe, hose clamp
2 P-clamp, 10 mm spacer sleeve, M6x20
bolt, flanged nut
4 Combustion-air intake pipe, 27 mm dia.
hose clamp
3 Protective cap
5 Mecanyl fuel line, hose section, 10 mm dia.
hose clamp [2x]
Installing
lines
5
2
1
3
6
2 3 41
7
3
1
5
3
2
4
8
1 2
4
3
5