Owner`s manual

Page 4 of 20

Installation:

Open box and remove contents. Check to make sure that the following parts are

included within kit:

Qty Description Part Number

2 12”x 26” Seat Heater Pad 30-0108-MW

1 Wire Harness Assembly 30-4200004

1 Switch Assembly 30-0213-MW

4 Black Tape Strips 30-0110-MW

4 Gold Tape Strips 30-0109-MW

1 Red T-Tap Connector 88-2300003

1 Blue T-Tap Connector 88-167000-TT

1 Yellow T-Tap Connector 88-2300002

2 Male Spade Connector 88-167000-MS

10 Wire Ties 88-8880001

Seat Cushion:

1. Prior to removing seat from vehicle, lay heating pads on seat to verify size & fit.

2. Secure car on a level surface.

3. Disconnect the negative battery cable or make sure that the area to be worked within is

grounded. If you have any doubt concerning the layout of the vehicle wire harness, consult

the wiring diagram provided by the manufacturer.

4. Remove seat from vehicle and place on a suitable work table/area.

Note: Make certain to disconnect all wire connectors prior to removing seat from

vehicle.

5. Disassemble seat as needed to gain access to seat cushion cover attachment clips.

6. Unsnap j-clips and or remove

“hog ring” clips and peel

back cover. See Fig 1 & 2

Fig 1

Fig 2 Note: If trim cover has hook and loop

style tie down, care must be taken

when removin

cover.