Service manual

Webasto Diesel Cooker X 100 5 Updating and repair
504
5.3 Burner
Complete burner cylinder
(Includes all parts you see in the picture.)
Thermal radiator for the burner
Detaching the thermal radiator:
There are two locking plates on the inside of the
burner’s “perforated” cylinder, which have been spot
welded to the sides of the cylinder. Prying one of the
locking plates with a screw driver against the side of
the cylinder, for example, should be enough to free the
thermal radiator and pull it up.
Installing the thermal radiator:
Push the thermal radiator inside the “perforated”
cylinder until the locking plates lock the thermal
radiator in place.
Note! The locking plates must be bent a bit
crosswise before you can assemble the thermal
radiator back in place. This will ensure that the
thermal radiator will stay in place during transport
as well.
Burner cylinder
Burner’s bottom mat spring
The bottom mat spring for the burner ensures that the
bottom mat stays on the bottom of the burner prevent-
ing the glow plug from going under the bottom mat.
Bottom mat of the burner, Ø 85 mm
(Delivered together with the bottom mat spring.)
Base of the burner
Installation
hole for glow
plug
Through pipe for
the temperature
sensor (T4)
Installation hole
and needle
support for the
fuel needle
Removing deposits:
Mechanically remove deposits by using a screw driver,
for example. Scrape all of the inner surfaces of the
burner clean and replace the bottom mat of the burner.