Specifications

Operation / Installation Manual – FCF 5,000, 9,000, 12,000, 16,000
Page 16
OPERATION
WIRED DISPLAY CONTROL OPERATION
Don't install the wired display in a location where it can get wet.
1. Display Receiver
6. Fan Speed Button
2. Digital Display
7. Temp. Setting Button / Increasing
3. Fan Speed Display (HIGH-MID-LOW and Auto Speed)
8. Temp. Setting Button / Decreasing
4. Display of Mode Operation (COOL-DEHUMIDIFY-HEAT and AUTO)
9. On/Off Button
5. Mode Button
This manual controller has memory function, if power off happened during the operation, the controller will
memorize the status of ON/OFF, operation mode, set temperature, operation fan speed, temperature display
format and time of starting interval. After powering on, the manual controller will display the setting status before
power off / power loss; if the unit was turned on prior to the loss of power the units fan(s) will immediately turn on.
After 1 minute the compressor will start and run in the status in which it was set prior to the power off / power loss.
In cooling / heating / dehumidify modes, the pump starts before the compressor starts and stops 5
seconds after the compressor. This functionality is normal.