Technical data

6.Function Test DBW 2010 / 2012 / 2020 / 2022 / 300 / 350
604
6.3.3 Checking and setting the ignition
electrodes
WARNING
ł There should be no damage on the insulation
elements of the ignition electrodes. Adjust or replace
the ignition electrodes, of which the electrode
distance is outside the tolerance or which do not work
in an orderly manner.
ł The ignition electrodes can be adjusted using a
gauge. For this, the front edge of the gauge must
lean on the vaporizer nozzle and the ends of the
ignition electrodes must be in two nicks.
Test
- Check out whether or not there is any damage on the
insulation element of the ignition electrodes.
ATTENTION
Do not touch the nozzle hole during the measurement of
the electrode distance in order to prevent affecting the
fuel spraying.
- Adjust the electrode distance with the gauge as
shown in the figure and check the status of the
electrodes.
Setting
Adjust the electrode distance by twisting and check with
the gauge as shown in the figure.
6.3.4 Testing the induction bobbin
DANGER
The high voltage creates approximately an 8.000 Volt arc
at the ignition electrodes.
ATTENTION
Do not give voltage to the induction bobbin without the
ignition electrodes.
Test
WARNING
Connect the positive side of the direct current to the black
cable and the negative to the brown cable.
- Give 12 or 24 Volt direct current.
- The situation that should be: there should be sparks
at the ignition electrodes.